用Verilog实现并串装换

摘要

一、并串转换模块

       并串转换的原理是：先将八位数据暂存于一个四位寄存器器中，然后左移输出到一位输出端口，这里通过load_valid信号指示并行数据输入。

1.1 用移位寄存器实现

module parallel_serial(clk, rst_n, load_valid, data_i, ser_data_o
);input clk, rst_n, en;
input [7:0]    para_data_in;
output         ser_data_o;reg [7:0]  data_buf;always @(posedge clk or negedge rst_n) beginif (rst_n == 1'b0) beginser_data_o <= 1'b0;data_buf   <= 8'b0;endelse if (load_valid == 1'b1)data_buf <= para_data_in;elsedata_buf <= data_buf << 1; 	//将寄存器内的值左移，依次读出//data_buf <= {data_buf[6:0],1'b0};
endassign ser_data_o = data_buf[7];endmodule

1.2 用计数器实现

module b_c(clk, rst_n, valid, para_data_in, ser_data_out);
input clk, rst_n;
input [3:0] para_data_in;
output reg  valid;
output reg  ser_data_o;reg [3:0]  count;
reg [3:0]  data;always @(posedge clk or negedge rst_n) beginif(~rst_n) begincount      <= 0;valid      <= 0;;data       <= para_data_in;ser_data_o <= 0;endelse beginif(count < 4) begincount         <= count + 1;valid         <= 1;data          <= {data[2:0], data[3]};ser_data_o    <= data[3];endelse begincount         <= 0;valid         <= 0;ser_data_o    <= 0;endend
endendmodule